LUSEP PPS

LUSEP PPS is a partially crystalline engineering resin known for dimensional stability.

It has an excellent chemical resistance and resistance to corrosive and high temperature environments and it has a very low moisture absorption.

LUSEP PPS has improved key properties by reinforcement:

  • Heat resistance: strength and high rigidity over wide ranges of temperature continuous usage temperature at 200°C or higher
  • Excellent dimensioal stability under high temperature and huminity environment
  • Low thermal expansion and mold shrinkage
Additional product information
Find out more by clicking the headings below to expand each section
Product range
  • General purpose
  • High impact
  • Low flash
  • Metal adhesion
  • Low Friction & Wear resistance
  • Epoxy adhesion
  • Highly filled
Advantages
  • Hydrolytic stability in hot water applications
  • Exceptionally high modulus and creep resistance
  • 'Lead-free' solution, no heavy metal content
  • Extremely low moisture absorption
  • Precision molding to tight tolerances with high reproducibility
  • Exceptional thermal and dimensional stability
  • Low smoke density
  • Low wear
Typical applications
  • Automotive parts like water pump impeller, thermostat sleeve, sensor and alternator brush holder, ABS brake components
  • Halogen light bulb holders
  • High temperature housings
  • HVAC applications
  • Lift and centrifugal pumps and impellers
  • Microwave control modules
  • Oil, chemical and vacuum pumps
  • Power converters
  • Transmission pistons
Product availability
  • Benelux
  • Denmark
  • Finland
  • Norway
  • Sweden
Processing
  • Injection molding
  • Pre-drying: 3-5 hours at 120-140°C is recommended
  • Cylinder temperature: 290-330°C is recommended
Find the product data you need

Looking for Datasheets & UL Yellow Cards?

Select the grade from the below list.

Grades
Compare grades
Additional product information
Find out more by clicking the headings below to expand each section
Product range
  • General purpose
  • High impact
  • Low flash
  • Metal adhesion
  • Low Friction & Wear resistance
  • Epoxy adhesion
  • Highly filled
Advantages
  • Hydrolytic stability in hot water applications
  • Exceptionally high modulus and creep resistance
  • 'Lead-free' solution, no heavy metal content
  • Extremely low moisture absorption
  • Precision molding to tight tolerances with high reproducibility
  • Exceptional thermal and dimensional stability
  • Low smoke density
  • Low wear
Typical applications
  • Automotive parts like water pump impeller, thermostat sleeve, sensor and alternator brush holder, ABS brake components
  • Halogen light bulb holders
  • High temperature housings
  • HVAC applications
  • Lift and centrifugal pumps and impellers
  • Microwave control modules
  • Oil, chemical and vacuum pumps
  • Power converters
  • Transmission pistons
Product availability
  • Benelux
  • Denmark
  • Finland
  • Norway
  • Sweden
Processing
  • Injection molding
  • Pre-drying: 3-5 hours at 120-140°C is recommended
  • Cylinder temperature: 290-330°C is recommended